Cooling
Dry
Fan
25¢J
23¢J
¡·
Cooling
Cooling 25¢J above
Dry 23¢J¡ª 25¢J
Fan 23¢J below
¡·
Heating
Cooling 25¢J above
Dry 23¢J¡ª 25¢J
Heating 23¢J below
12
Cooling
Dry
Heating
25¢J
23¢J
AUTOMATIC OPERATION
To Select AUTOMATIC Operation
1Press the POWER ON/OFF button.
The air conditioner will start operation.
2Press the MODE CONTROL button to select AUTO.
The operating mode "AUTO " will appear alone in the display. The
transmit indicator will flash to indicate the command has been sent,
and the signal transmits after releasing button. While set to AUTO
mode, controller choices the operating mode depending on room
temperature. These status is set as shown.
About Automatic Operation
¡·
Depending on the room temperature at the time
operation begins, the operating mode will be switched
automatically as shown. Also, depending on the operating
mode, the room temperature setting will cause the
"normal " temperature to be set as shown.
¡·
Auto function is valid when POWER ON or when change
to AUTO mode from another status at first time, unit can
operate cooling, dry, fan, heating mode. The mode will
change no more, even if the room temperature changed.
1.When AUTO mode, temperature can be set increasing or
decreasing 2¢J, AUTO mode will re-judge one time.
2.When unit under AUTO mode operating, thermostat will re-
judge room temperature every one hour and execute the
appraisal mode.
¡·
In dry mode, fan operates as setting till room temperature is
lower than setting temperature, unit then changes to drying
mode, fan will operate at slow speed.
¡·
In the dry mode, the fan will operate slowly to prevent room
humidity from rising, and the room fan may stop.
To Next Page
Loading...
Need help?
General
