19
System Operating Status
This screen is displayed on units with Brazed Plate.
All Brazed Plate Units
Possible Values:
On, Off
1. Press the NEXT key until the followin
screen is displayed.
This screen is displayed when Hot Gas Bypass is installed.
Used on Units:
With Hot Gas Bypass option
Possible Values:
On, Off
1. Press the NEXT key until the followin
screen is displayed.
With Ice Building Control
Possible Values:
On, Off
1. Press the NEXT key until the followin
screen is displayed.
This screen is displayed when Leavin
Solution Setpoint Source
is selected.
With CGM Ext Leavin
Soln Setpoint
Source selected
Possible Values:
0 - 99
1. Press the NEXT key until the followin
screen is displayed.
2. Pressin
the NEXT key will display the be
innin
of
the Submenu.
3. Press the NEXT key a
ain to advance to the followin
screen.
CGM Hot Gas Bypass Control Relay: OFF
End Of Sub-Menu (NEXT) To Re-enter STATUS
CGM Ice Building Control Relay: ON
Setpoint Value Measured
CGM Ext Leaving Soln STP Input is 44.0 F
MCM Heat Tape Control Relay: OFF
1. Press the ENTER key until the following screen is displayed.
2. Press the NEXT key to bypass this menu and advance to
"Temperature Input Status Submenu"
Used on Units:
All Units
Possible Values:
Human Interface STP Menu,
Ext Leaving Soln STP Input,
GBAS 0-10 VDC Module,
GBAS 0-5 VDC Module,
BAS/NETWORK
Setpoint Range = 0 - 99.9 F
1. Press the NEXT key until the following screen is displayed.
This screen is displayed when Ice Building is enabled.
Used on Units:
With Ice Building Option
Possible Values:
Human Interface STP Menu,
Ext Leaving Soln STP Input,
GBAS 0-10 VDC Module,
GBAS 0-5 VDC Module,
BAS/NETWORK (Tracer) (TCI only)
Setpoint Range = 0 - 99.9 F
Active Leaving Solution Setpoint From
EXT LEAVING SOLN STP INPUT is 55.0 F
Active Ice Build Terminate Setpoint From
HUMAN INTERFACE STP MENU is 33.0 F
Controlling Setpoint Status Submenu
Press ENTER to View Data in This Submenu
To Next Page
Loading...
Need help?
General
