38
System Configuration
3. Press the NEXT key until the following screen is displayed.
Used on Units:
Possible Values:
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed.
Used on Units:
Possible Values:
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed.
Used on Units:
Possible Values:
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed.
The following displays are not editable.
Used on Units:
Possible Values:
1.0 or Greater
1. Press the NEXT key until one of the following screens is displayed.
Used on Units:
Possible Values:
1.0 or Greater
OR
Used on Units:
Possible Values:
1.0 or Greater
1. Press the NEXT key until the following screen is displayed.
Used on Units:
With GBAS 5VDC Module
Possible Values:
1.0 or Greater
1. Press the NEXT key until the following screen is displayed.
Used on Units:
Possible Values:
1.0 or Greater
1. Press the NEXT key until the following screen is displayed.
Used on Units:
With SSM Module
Possible Values:
1.0 or Greater
Configuration - Model Num Digit 13+
Current Sensing Module INSTALLED
Configuration - Model Num Digit 13+
BAS Communications Module INSTALLED
Configuration - Model Num Digit 13+
Remote Human Interface INSTALLED
Software Revision Number Report:
Cold Generator Module (CGM) 1.00
Software Revision Number Report:
Multiple Compressor Module (MCM) 1.00
Software Revision Number Report:
GBAS 0-5VDC Module 1.00
Software Revision Number Report:
GBAS 0-10VDC Module 1.00
Software Revision Number Report:
Superheat/Subcool Module (SSM) 1.00
Software Revision Number Report:
Single Compressor Module (SCM) 1.00
To Next Page
Loading...
Need help?
General
