Trane IntelliPak CGAF Series - Evap Soln Pump Off Delay; Low Ambient Compressor Lockout

26
System Programming SETUP
Used on Units:
All Units
Possible Values:
30 to 600 seconds
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed.
Used on Units:
All Units
Possible Values:
30 to 255 seconds
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed.
Used on Units:
All Units
Possible Values:
Enable, Disable
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed.
Used on Units:
All Units
Possible Values:
None - No Reset Applied
Outside Air Temp Reset
1. Press the + or - key until the proper value is displayed. Zone Temp Reset
2. Press the ENTER key to confirm this choice. Enterin
g
Solution Temp Reset
3. Press the NEXT key until the following screen is displayed.
The followin
g
two screens will display when either OA, Zone, or
ENT Soln Reset is selected.
1. Press the + or - key until the proper value is displayed.
Used on Units:
All Units with Leaving Solution Reset
2. Press the ENTER key to confirm this choice.
Possible Values:
3. Press the NEXT key to advance the cursor to the "End Temp" Reset Type: Outside Air Temp Reset
4. Press the + or - key until the proper value is displayed. Zone Temp Reset
5. Press the ENTER key to confirm this choice. Enterin
g
Soln Temp Reset
6. Press the NEXT key until the followin
g
screen is displayed.
Start Temp OA: 46 - 125 F
Zone: 67 - 81 F
ENT Soln Temp Reset: 6 - 80 F
End Temp OA: 45 - 124 F
1. Press the + or - key until the proper value is displayed.
Zone: 66 - 80 F
2. Press the ENTER key to confirm this choice. ENT Soln Temp Reset: 5 - 79 F
3. Press the NEXT key until the followin
g
screen is displayed. Max Amount (Zone, OA, ENT Soln Temp Reset): 3 - 16 F
1. Press the + or - key until the proper value is displayed.
Used on Units:
All Units
2. Press the ENTER key to confirm this choice.
Possible Values:
Comfort Coolin
g
, Process Coolin
g
3. Press the NEXT key until the followin
g
screen is displayed.
Evap Soln Pump Off Delay time 30 Sec
Delay Pump OFF Request By This Amount
Loop Stabilization Time: 120 Sec
Run Pump To Allow Soln Temp To Stabilize
Low Ambient Compressor Lockout: ENABLED
Use Low Ambient Compressor Lockout STP
Leaving Solution Reset Type:
NONE - NO RESET APPLIED
Select Type of Cooling Control Based On
Chiller Application: PROCESS COOLING
Reset Type: Outside Air Temp Reset
Start Temp 70.0 F End Temp 50.0 F
Reset Type: Outside Air Temp Reset
Maximum Amount of Reset A
pp
lied 5.0 F