SSP-SVX001B-EN
9
☐ Inspect unit location for proper free air clearances.
☐ Inspect unit location for secure, level mounting
position.
☐ Verify condenser fans turn freely without rubbing
and are properly tightened on the shafts.
Refrigerant Piping
☐ Properly sized/constructed liquid and suction lines
connected to stubs at both the indoor and outdoor
units?
☐ Insulated the entire suction line?
☐ Insulated portions of liquid line exposed to
extremes in temperature?
☐ Performed initial leak test?
☐ Evacuated each refrigerant circuit to 500 microns?
☐ Charged each circuit with proper amount of R-410A/
R-22?
Electrical Wiring
☐ Provided unit power wiring (with disconnect) to
proper terminals in the unit control enclosure?
☐ Installed system indoor thermostat or zone sensor?
☐ Installed system low voltage interconnecting wiring
to proper terminals of outdoor unit, indoor unit and
system thermostat or zone sensor?
☐ Checked all electrical connections to verify all are
properly tightened and connected?
☐ Verified operation of crankcase heaters?
PPrree--IInnssttaallllaattiioonn
To Next Page
Loading...
Need help?
General
