6 BAS-SVN028K-EN
Installation
Location Guidelines
• Do not install on an outside wall.
• Do not install in areas with direct heat source.
• Do not install near any air discharge grill.
• Do not install in areas exposed to direct sunlight.
• Ensure the sensor has sufficient air circulation.
• Ensure the mounting wall surface is flat and clean.
Installing the Sensor
1. Remove the security screw from the bottom of the
sensor (if present).
2. Firmly grasp the sensor and pull up on the bottom to
remove the front cover.
3. Feed the wires from the wall through the backside of
sensor base.
4. Ensure the sensor is oriented correctly. The word 'TOP'
is embossed on the backplate to indicate correct
orientation. Mark the top/bottom mounting hole
locations on the wall.
5. Install the provided wall anchors and then affix the
sensor base to the wall using the provided screws.
6. Strip the wire coating from the ends of each wire
approximately 0.25 inch.
7. Insert the wires into the wire terminals (per terminal
identification below) and tighten down the terminal
screws to secure wire.
8. Push any excess wire back into the wall and then
replace the sensor cover. Once the cover snaps on, the
sensor powers up.
9. Replace the security screw on the bottom of the sensor
to avoid tampering.
To Next Page
Loading...
