RLC-SVX19J_SHORT-GB
30
Controls Overview
Sintesis RTAF units use the following control/interface
components:
• Tracer™ UC800 Controller
• Tracer TD7 Operator Interface
Communication Interfaces
There are four connections on the UC800 that support
the communication interface. See RTAF User Guide
to locate the following ports: “Wiring and Ports
Description” section.
• BACnet MS/TP
• MODBUS Slave
• LonTalk using LCI-C (from the IPC3 bus)
See chiller User Guide for information on
communication interface.
Tracer TD7 Operator Interface
Operator Interface
Information is tailored to operators, service technicians
and owners. When operating a chiller, there is specifi c
information you need on a day-to-day basis, like
setpoints, limits, diagnostic information, and reports.
Day-to-day operational information is presented at the
display. Logically organized groups of information-chiller
mode of operation, active diagnostics, settings and
reports put information conveniently at your fi ngertips.
Tracer™ TU
The TD7 operator interface allows for daily operation
tasks and setpoint changes. However to adequately
service Sintesis RTAF chillers, Tracer™ TU service tool is
required (Non-Trane personnel, contact your local Trane
offi ce for software purchase information). Tracer TU adds
a level of sophistication that improves service technician
effectiveness and minimizes chiller downtime. This
portable PC-based service-tool software supports service
and maintenance tasks.
Controls/Tracer TD7 Operator Interface
To Next Page
Loading...
