Trane Symbio CVRF - Adjusting the Tracer Adaptiview  Display Arm

Installation
16 CVRF-SVN005C-EN
Adjusting the Tracer® AdaptiView™ 
Display Arm
The Tracer® AdaptiView™ display arm may be too loose or too
tight and in need of adjustment. To adjust the tension on the
display arm:
1. There are three joints on the display arm that allow the
T
racer® AdaptiView™ display to be positioned at a variety
of heights and angles (refer to items labeled 1, 2, and 3 in
Figure 7, p. 16). At each joint in the display arm there is
e
ither a hex bolt (1 and 2) or hex screw (3). Turn the hex
bolt or screw in the proper direction to increase or decrease
tension.
Note: Each hex bolt or screw is labeled with ‘loosen’/
‘tighten’, or '+'/'–' indicators.
Figure 7. Joint locations on the display arm
2. Joint 3 has a 6 mm hex screw controlling the tension on a
gas spring, which allows the Tracer® AdaptiView™ display
to tilt up and down.
3. Joints 1 and 2 are covered by a plastic cap. Remove the
plastic cap to access
the hex bolt. Adjust using a 13 mm
wrench as necessary.
4. To adjust the swivel of the T
racer® AdaptiView™ display
(the spin right and left similar to the steering wheel on a
car), you need to adjust the hex bolt located inside the
display arm back plate. This adjustment needs to be done
BEFORE attaching the display. Use a 9/16-inch or 14 mm
wrench.
5. Use a 13 mm wrench to adjust the bolt (item labeled 4 in
Figure 7, p. 16) that allows the entire display arm to swivel
to
the left and right.
1
3
4
2