Trane TPWCCMV0300D3-MM - User Manual

February 2021
ARTC-SVX002A-EN
SAFETY WARNING
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of
heating, ventilating, and air-conditioning equipment can be hazardous and requires specific knowledge and training.
Improperly installed, adjusted or altered equipment by an unqualified person could result in death or serious injury.
When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that are
attached to the equipment.
Manhattan™ Gen II Water-Cooled
Modular Chiller
Installation, Operation, and Maintenance

Trane TPWCCMV0300D3-MM Specifications

General

Category	Chiller
Model	TPWCCMV0300D3-MM
Cooling Capacity	300 tons
Refrigerant Type	R-134a
Voltage	460V
Phase	3
Frequency	60 Hz
Compressor Type	Centrifugal

Summary

Introduction

Safety Advisories and Policies

Defines safety advisories (Warning, Caution, Notice) and EHS policies for safe operation.

Pre-Installation

Preparation and Initial Startup

Details steps before initial startup, ensuring cooling load and safety.

Startup Readiness Checklist

Installation Mechanical

Inspect and Report Damage

Installation Piping

Installation Electrical

Module Power and Control Wiring

Operating Principles

Operator Interface and Control

Microprocessor and HMI Functions

Details c.pCO controllers, client/server roles, password protection, and HMI operation.

Module Status, Alarms, and Trends

System Operation and Safety

Covers power up, shutdown, water/glycol management, and safety procedures.

Controls and System Parameters

Controls Interface

Microprocessor Control Systems

Details c.pCO systems, client/server controllers, and touchscreen interface panels.

Power and Electrical Controls

Refrigeration System Controls

Sequence of Operations

Constant Flow Operation

Details the operational sequence for chillers in constant flow mode.

Variable Flow Operation

Describes the operational sequence for chillers in variable flow mode, including VFD pumps.

Chiller Performance Data

Maintenance Procedures

Maintenance Strategy and Schedules

Outlines maintenance strategy, schedules, and safety precautions.

Inspection and Task Procedures

Component Maintenance

Covers critical cleaning, evaporator, compressor, pump, and seal maintenance.

Controller Replacement

Chiller Troubleshooting

Fault Isolation and Diagnostic Codes

Covers fault isolation approach and controller diagnostic codes.

Compressor Faults and CoreSense

Details compressor diagnostic codes, flash codes, and summaries.

VFD Faults and Symptoms

Common Symptoms and Solutions

Provides solutions for common issues like compressor not running, noise, pressure, and temperature problems.

Appendix B - Request for Initial Startup

Startup Data and Requirements

Initial Startup Agreement