CTV-SVU01G-EN
19
Figure 7. Shutting Down Chiller screen
NNoottee:: If the chiller is a Duplex™, the screen shows top-level modes and submodes for both
the chiller and the two circuits.
Restarting the Chiller
Touch the Auto button to initiate the chiller restart process. You can observe the mode change to
Auto. The chiller will wait until cooling is needed before starting the compressor.
When the chiller is running normally, it automatically starts and stops as needed to reach its
setpoints.
SSttooppppiinngg//RReessttaarrttiinngg CChhiilllleerr OOppeerraattiioonn
To Next Page
Loading...
Need help?
General
