Transcend Micro - Device Button Functions; Ramp Button and LEDs; Dry Cycle Button and LEDs

Page 11
Bluetooth indicator light is green
Bluetooth communication is enabled and there
is an active connection with a mobile device.
Bluetooth indicator light is white
Bluetooth communication is disabled.
Therapy Mode
Pressing the Bluetooth button has no effect while in Therapy Mode.
Bluetooth indicator light is off
Therapy Mode is on.
Ramp button and LED indicators
Standby Mode
• The LED glows blue if Ramp is configured and auto-ramp is enabled.
o If therapy is started when the ramp LED is on, the device will begin at a
lower, ramp pressure. Device will arrive with Ramp enabled.
• The LED is off if Ramp is not configured, or Auto Ramp is disabled.
o If therapy is started when the ramp LED is off, the device will begin at the
starting therapy pressure.
• Pressing the button when Ramp is not configured has no effect.
o See Transcend desktop software user guide to configure
https://mytranscend.com/customer-care/user-guides/
• Pressing the button when Ramp is configured toggles Auto Ramp between enabled
and disabled.
Therapy Mode
• The LED is off.
• If Ramp is active, pressing and holding the button accelerates Ramp increase.
• If Ramp is configured but not active, pressing the button starts Ramp.
• If Ramp is not configured, pressing the button has no effect.
Dry cycle button and LED indicators
Standby Mode
• The LED is off when Drying Mode is off.
• The LED glows blue when Dry Cycle is on.
• Pressing the Dry Cycle button toggles between on and off.