Transcend Micro - Disconnecting Comfort Features; Whispersoft Muffler Assembly; Airmist HME Adapter Assembly

Page 15
• Do not open or modify the device. There are no user-serviceable parts inside the
device. Servicing and repairs should only be performed by an authorized Transcend
person.
• Do not use chlorine, bleach or scented cleaning solutions, antibacterial or
moisturizing soaps or oils, including scented oils, to clean the device or its
components. These solutions may damage the device or reduce its life.
• Exposure to smoke, including cigarette, cigar or pipe smoke may damage the
device.
• Exposure to ozone or other gases may damage the device. Damage caused by not
following this Warning will not be covered by Transcend’s limited warranty.
Disconnecting Comfort Features
WhisperSoft muffler assembly
1. Remove the short air hose from the device, by twisting the connector left or
counterclockwise and pulling the hose away from the device. Disconnect the other
end of the hose from the muffler.
2. Remove the muffler from one end of your long hose and your mask from the other
end of the hose.
3. After following the cleaning process, refer to steps in the Connecting Comfort
Feature section to reassemble the muffler.
AirMist HME adapter assembly
to device

to mask
➔
a
b
c
a. Short air hose
b. WhisperSoft muffler
c. Long air hose
to device

to mask
➔
a
b
a. Air hose
b.
HME adapter bottom
c. HME cartridge
d. HME adapter top
c
d
v
v
v