Transducer Techniques DPM-3 User Manual

- 22 -
Option board dependent menu items
ALSEt. ALS34 dEU1H dEU2H dEU1b dEU2b dEU3H DEU4H DEU3b DEU4b
Menu items related to alarm setup These will only appear if a relay board is detected. If so,
please see Section14.
AnSEt. An Lo. An Hi..
Menu items related to analog output setup. These will only appear if an analog output
board is detected. If so, see Section 15.
MENU
KEY
DIGIT SELECT
KEY
VALUE SELECT KEY
tArE_
Tare selec-
tions.
00000 Calibration
due indicator.
0 Calibration due indicators enabled
1 Calibration due indicators disabled
00000 Front panel
pushbutton Tare.
0 Front panel tare enabled
1 Front panel tare disabled
00000
Auto-Tare.
0 Tare after meter reset
1 No tare after meter reset
Option board dependent menu items
SEr 1. SEr 2. SEr 3. SEr 4. _Addr
Menu items related to serial communications. These will only appear if an RS232,
RS485, or USB I/O board is detected. If so, see Section 16.
CAL rt
Cal Reset
The Cal Instrument indicator starts flashing 30 days before instrument
calibration is due. To acknowledge and turn off flashing, change the first
digit of this menu item from 1 to 0. The Cal Sensor indicator starts
flashing 30 days before sensor calibration is due. To acknowledge and
turn off flashing, change the second digit of this menu item from 1 to 0.
dAtE
Current date
Use the keypad to enter the current date in MM.DD.YY format. This
menu item appears as an error message when the battery has just been
replaced, or in other instances where the date in the instrument cannot
be correct. The meter remains non-functional until the current date has
been entered.
CALd II
Calibration date of instrument in MM.DD.YY format.
Menu lockout items
Loc 1. Loc 2. Loc 3.
Menu items used to enable or lock out (hide) other menu items. Loc menu items may in
turn be locked out by a hardware jumper. Please see Section 8.

Transducer Techniques DPM-3 Specifications

General

Brand	Transducer Techniques
Model	DPM-3
Category	Measuring Instruments
Language	English