LoG Data Logging.
Items logged to Memory
are Displayed value, Date,
Time, Units, Value Type,
Alarms, and Overload.
Items logged to USB are
selectable to conserve
bandwidth.
00000 Units of measure
and Value Type logged
via serial communications.
0 Do not send Units or Value Type.
1 Send Units, not Value Type.
2 Send Value type, not Units.
3 Send both Value type and Units.
00000 Time and Date
logged via serial commu-
nications.
0 Don’t send Time or Date.
1 Send Time, not Date.
2 Send Date, not Time.
3 Send both Date and Time.
00000 Memory # logged
via serial communications.
0 Don’t send Memory # address.
1 Send Memory # address.
00000 Memory Protect
to prevent overwriting.
0 Memory Protect enabled.
1 Memory Protect disabled.
00000 Logging destina-
tion and serial Recall
selections.
0 Logging disabled.
1 Log to Memory only.
2 Log to serial only. Serial Recall.
3 Log to both Memory & serial.
Serial Recall.
ALErt Visual and audio
alerts. 4 digits only.
0000 Audio warning
before auto power-off
0000 Non-use power-off
interval
0 Disabled 2 30 min
1 15 min 3 60 min
00.00.00 00.00.00
00.00.00 00.00.00
00.00.00 00.00.00
Select digit to flash.
Select 0 thru 9 for flashing digit to
set time in 24-hour format: 23.59.59
Select 0 thru 9 for flashing digit to
set date in MM.DD.YY format.
CALrt Cal Reset.
Starts as 0. Automatically
set to 1 when calibration
is due in 30 days, causing
CAL to flash. To acknow-
ledge and stop flashing,
reset digit to 0.
0 CAL INSTRUMENT not flashing
1 CAL INSTRUMENT flashing
00 CAL SENSOR
(if TEDS sensor is present)
0 CAL SENSOR not flashing
1 CAL SENSOR flashing
The menu item below is read from the instrument and is read-only.
Calibration date of instrument in MM.DD.YY format.
To Next Page
Loading...
Need help?
General
