Transition Networks SISTM1040-262D-LRT - Port Commands Set

24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600
128
Port Commands Set
Commands Level Description Example
interface fastEthernet
[Portid]
G Choose the port for
modification.
switch(config)#interface
fastEthernet 2
duplex
[full | half]
I Use the duplex
configuration
command to specify
the duplex mode of
operation for Fast
Ethernet.
switch(config)#interface
fastEthernet 2
switch(config-if)#duplex full
speed
[10|100|1000|auto]
I Use the speed
configuration
command to specify
the speed mode of
operation for Fast
Ethernet., the speed
can’t be set to 1000 if
the port isn’t a giga
port..
switch(config)#interface
fastEthernet 2
switch(config-if)#speed 100
no flowcontrol I Disable flow control of
interface
switch(config-if)#no flowcontrol
security enable I Enable security of
interface
switch(config)#interface
fastEthernet 2
switch(config-if)#security enable
no security I Disable security of
interface
switch(config)#interface
fastEthernet 2
switch(config-if)#no security
bandwidth type all I Set interface ingress
limit frame type to
“accept all frame”
switch(config)#interface
fastEthernet 2
switch(config-if)#bandwidth type
all