Transition Networks SISTM1040-262D-LRT - QOS Commands Set

24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600
136
into the forwarding
state.
stp-path-priority
[Port Priority]
I Use the spanning-tree
port-priority interface
configuration
command to configure
a port priority that
is used when two
switches tie for
position as the root
switch.
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-path-priority
128
stp-admin-p2p
[Auto|True|False]
I Admin P2P of STP
priority on this
interface.
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-admin-p2p
Auto
stp-admin-edge
[True|False]
I Admin Edge of STP
priority on this
interface.
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-admin-edge
True
stp-admin-non-stp
[True|False]
I Admin NonSTP of
STP priority on this
interface.
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-admin-non-
stp False
show spanning-tree E Displays
a summary of
the spanning-tree
states.
switch>show spanning-tree
no spanning-tree G Disable spanning-tree. switch(config)#no spanning-tree
QOS Commands Set
Commands Level Description Example
qos policy G Select QOS policy switch(config)#qos policy