Transition Networks SISTM1040-262D-LRT - VLAN Commands Set

24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600
132
no aggregator group
[GroupID]
G Remove a trunk group switch(config)#no aggreator
group 2
VLAN Commands Set
Commands Level Description Example
vlan database P Enter VLAN configure
mode
switch#vlan database
Vlanmode
[portbase| 802.1q |
gvrp]
V To set switch VLAN
mode.
switch(vlan)#vlanmode portbase
or
switch(vlan)#vlanmode 802.1q
or
switch(vlan)#vlanmode gvrp
no vlan V No VLAN Switch(vlan)#no vlan
Ported based VLAN configuration
vlan port-based
grpname
[Group Name]
grpid
[GroupID]
port
[PortNumbers]
V Add new port based
VALN
switch(vlan)#vlan port-based
grpname test grpid 2 port 2-4
or
switch(vlan)#vlan port-based
grpname test grpid 2 port 2,3,4
show vlan [GroupID]
or
show vlan
V Show VLAN
information
switch(vlan)#show vlan 23
no vlan group
[GroupID]
V Delete port base
group ID
switch(vlan)#no vlan group 2
IEEE 802.1Q VLAN
vlan 8021q name
[GroupName]
vid
[VID]
V Change the name of
VLAN group, if the
group didn’t exist, this
command can’t be
applied.
switch(vlan)#vlan 8021q name
test vid 22