Transition Networks SISTM1040-262D-LRT - Spanning Tree Commands Set

24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600
134
Spanning Tree Commands Set
Commands Level Description Example
spanning-tree enable G Enable spanning tree switch(config)#spanning-tree
enable
spanning-tree priority
[0~61440]
G Configure spanning
tree priority parameter
switch(config)#spanning-tree
priority 32768
spanning-tree max-age
[seconds]
G Use the spanning-tree
max-age global
configuration
command to change
the interval between
messages the
spanning tree receives
from the root switch. If
a switch does not
receive a bridge
protocol data unit
(BPDU) message from
the root switch within
this interval, it
recomputed the
Spanning Tree
Protocol (STP)
topology.
switch(config)#spanning-tree
max-age 15
spanning-tree hello-
time [seconds]
G Use the spanning-tree
hello-time global
configuration
command to specify
the interval between
hello bridge protocol
switch(config)#spanning-tree
hello-time 3