28 NX-Platform Hardware Installation and Safety
Module name Ports Port speed Part number
1-Segment 40GbE QSFP+ NX (QSFP+) 2 Fiber 40Gbps TPNN0069
Note: If you insert an SFP into a 10GbE module slot, the port might go down. To use an SFP in a 10GbE
module, configure the slot by entering the following command in the command line interface:
conf term interface ethernet 1-1A negotiate
OR
conf term interface ethernet 1-1A no negotiate
conf term interface ethernet 1-1A linespeed 1000
You can revert to SFP+ by inserting an SFP+ into the 10GbE module and entering the following command
in the command line interface:
conf term interface ethernet 1-1A no negotiate
conf term interface ethernet 1-1A linespeed 10000
NX-Platform devices support the following bypass I/O modules:
Module name Ports Port speed Part number
NX IPS 4-Segment Gig-T Bypass Module 8 Copper 10/100/1000
Mbps
TPNN0070
To Next Page
Loading...
