17
Setting up the TCP/IP in Windows
The instruction in this chapter will help you configure your computers to be able to communicate with this
TDM-C500 ADSL2/2+ Modem Router.
Computers access the Internet using a protocol called TCP/IP (Transmission Control Protocol/ Internet
Protocol). Each computer/notebook on your network must have TCP/IP installed and selected as its
networking protocol. If a Network Interface Card (NIC) is already installed in your PC, then TCP/IP is probably
already installed as well.
The following description assumes TDM-C500 ADSL2/2+ Modem Router been set to factory default. (If
not, please hold the reset button down for 5~10 seconds). The default of the TDM-C500 ADSL2/2+ Modem
Router’s LAN IP is 192.168.10.1.
Follow the procedures below to set your computer/notebook function as a DHCP Client.
!
Restart and Reboot your Windows system might be necessary after setting your
computer function as a DHCP Client. In order to properly activate your choice, click
“OK” to restart your Windows system.
To Next Page
Loading...
