To Next Page

To Previous Page

Access Point Setup

7. From the menu, check the following screens, and configure as necessary for your environ-

ment. Details of these screens and settings are described in the following sections of this

chapter.

• System - Basic and Advanced settings

• Wireless - Basic, Advanced, Access Control, Radius Server, Virtual APs & WIFI Pro-

tected Setup.

8. You may also wish to set the admin password and administration connection options.

These are on the Admin Login screen accessed from the Management menu. See Chapter

6 for details of the screens and features available on the Management menu.

9. Use the Apply and Reboot buttons on the menu to apply your changes and restart the

Wireless Access Point.

Setup is now complete.

Wireless stations must now be set to match the Wireless Access Point. See Chapter 4 for details.

If you can't connect:

It is likely that your PC’s IP address is incompatible with the Wireless Access

Point’s IP address. This can happen if your LAN does not have a DHCP Server.

The default IP address of the Wireless Access Point is 192.168.0.228, with a

Network Mask of 255.255.255.0.

If your PC’s IP address is not compatible with this, you must change your PC’s IP

address to an unused value in the range 192.168.0.1 ~ 192.168.0.254, with a Net-

work Mask of 255.255.255.0. See Appendix C - Windows TCP/IP for details for

this procedure.

TRENDnet TEW-636APB User Manual

Other manuals for TRENDnet TEW-636APB