TRENDnet TI-PG541i - Page 115

© Copyright 2019 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
Industrial Managed Switch Series
112
CLI Configuration
Node
Command
Description
enable
show traffic-monitor
This command displays the traffic monitor
configurations and current status.
configure
traffic-monitor
(disable|enable)
This command enables / disables the traffic
monitor on the Switch.
interface
traffic-monitor
(disable|enable)
This command enables / disables the traffic
monitor on the port.
interface
traffic-monitor rate
RATE_LIMIT type
(bcast|mcast|bcast+mcast)
This command configures the packet rate
and packet type for the traffic monitor on
the port.
bcast – Broadcast packet.
mcast – Multicast packet.
interface
traffic-monitor recovery
(disable|enable)
This command enables / disables the
recovery function for the traffic monitor on
the port.
interface
traffic-monitor recovery
time VALUE
This command configures the recovery
time for the traffic monitor on the port.
configure
interface range
gigabitethernet1/0/
PORTLISTS
This command enters the interface
configure node.
if-range
traffic-monitor
(disable|enable)
This command enables / disables the traffic
monitor on the port.
if-range
traffic-monitor rate
RATE_LIMIT type
(bcast|mcast|bcast+mcast)
This command configures the packet rate
and packet type for the traffic monitor on
the port.
bcast – Broadcast packet.
mcast – Multicast packet.
if-range
traffic-monitor recovery
(disable|enable)
This command enables / disables the
recovery function for the traffic monitor on
the port.
if-range
traffic-monitor recovery
time VALUE
This command configures the recovery
time for the traffic monitor on the port.
Web Configuration
Monitor > Traffic Monitor
Parameter
Description
State
Globally enables / disables the traffic monitor function.
Port
The port range which you want to configure.
State
Enables / disables the traffic monitor function on these ports.
Action
Unblock these ports.
Packet Type
Specify the packet type which you want to monitor.
Packet Rate
Specify the packet rate which you want to monitor.
Recover State
Enables / disables the recovery function for the traffic monitor
function on these ports.
Recovery Time
Configures the recovery time for the traffic monitor function on
these ports.(Range: 1 – 60 minutes)