TRENDnet TI-PG541i - Page 52

© Copyright 2019 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
Industrial Managed Switch Series
49
224.0.0.9
The RIP version 2 group address, used to send routing information
using the RIP protocol to all RIP v2-aware routers on a network
segment
224.0.0.10
EIGRP group address. Used to send EIGRP routing information to all
EIGRP routers on a network segment
224.0.0.13
PIM Version 2 (Protocol Independent Multicast)
224.0.0.18
Virtual Router Redundancy Protocol
224.0.0.19 - 21
IS-IS over IP
224.0.0.22
IGMP Version 3 (Internet Group Management Protocol)
224.0.0.102
Hot Standby Router Protocol Version 2
224.0.0.251
Multicast DNS address
224.0.0.252
Link-local Multicast Name Resolution address
224.0.1.1
Network Time Protocol address
224.0.1.39
Cisco Auto-RP-Announce address
224.0.1.40
Cisco Auto-RP-Discovery address
224.0.1.41
H.323 Gatekeeper discovery address
CLI Configuration
Node
Command
Description
enable
show mac-address-table
multicast
This command displays the current
static/dynamic multicast address
entries.
configure
mac-address-table multicast
MACADDR vlan VLANID ports
PORTLIST
This command configures a static
multicast entry.
configure
no mac-address-table
multicast MACADDR
This command removes a static
multicast entry from the address table.
Web Configuration
Advanced Settings > IGMP Snooping > Multicast Address
Parameter
Description
VLAN ID
Configures the VLAN that you want to configure.
MAC
Address
Configures the multicast MAC which will not be aged out.
Valid format is hh:hh:hh:hh:hh:hh.
Port
Configures the member port for the multicast address.
Apply
Click Apply to save your changes back to the Switch.
Refresh
Click Refresh to begin configuring this screen afresh.