TRENDnet TI-PG541i - Page 68

© Copyright 2019 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
Industrial Managed Switch Series
65
CLI Configuration
Node
Command
Description
enable
show lacp counters [GROUP_ID]
This command displays the LACP
counters for the specific group or
all groups.
enable
show lacp internal [GROUP_ID]
This command displays the LACP
internal information for the specific
group or all groups.
enable
show lacp neighbor [GROUP_ID]
This command displays the LACP
neighbor’s information for the
specific group or all groups.
enable
show lacp port_priority
This command displays the port
priority for the LACP.
enable
show lacp sys_id
This command displays the actor’s
and partner’s system ID.
configure
lacp (disable | enable)
This command disables / enables
the LACP on the switch.
configure
lacp GROUP_ID (disable |
enable)
This command disables / enables
the LACP on the specific trunk
group.
configure
clear lacp counters [PORT_ID]
This command clears the LACP
statistics for the specific port or all
ports.
configure
lacp system-priority<1-65535>
This command configures the
system priority for the LACP. Note:
The default value is 32768.
configure
no lacp system-priority
This command configures the
default for the system priority for
the LACP.
interface
lacp port_priority <1-65535>
This command configures the
priority for the specific port.
Note: The default value is 32768.
interface
no lacp port_priority
This command configures the
default for the priority for the
specific port.
configure
interface range
gigabitethernet1/0/PORTLISTS
This command enters the interface
configure node.
if-range
lacp port_priority <1-65535>
This command configures the
priority for the specific ports.
Note: The default value is 32768.
if-range
no lacp port_priority
This command configures the
default for the priority for the
specific ports.