TRENDnet TI-PG541i - Page 86

© Copyright 2019 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
Industrial Managed Switch Series
83
configure
no spanning-tree hello-time
This command configures the
default values for hello-time.
configure
spanning-tree max-age<6-40>
This command configures the
bridge message max-age time(sec).
configure
no spanning-tree max-age
This command configures the
default values for max-age time.
configure
spanning-tree mode (rstp|stp)
This command configures the
spanning mode.
configure
spanning-tree pathcost method
(short|long)
This command configures the
pathcost method.
configure
spanning-tree priority<0-61440>
This command configures the
priority for the system.
configure
no spanning-tree priority
This command configures the
default values for the system
priority.
interface
spanning-tree (disable|enable)
This command configures
enables/disables the STP function
for the specific port.
interface
spanning-tree bpdufilter
(disable|enable)
This command configures
enables/disables the bpdufilter
function for the specific port.
interface
spanning-tree bpduguard
(disable|enable)
This command configures
enables/disables the bpduguard
function for the specific port.
interface
spanning-tree rootguard
(disable|enable)
This command enables/disables the
BPDU Root guard port setting for
the specific port.
interface
spanning-tree edge-port
(disable|enable)
This command enables/disables the
edge port setting for the specific
port.
interface
spanning-tree cost VALUE
This command configures the cost
for the specific port.
Cost range:
16-bit based value range 1-65535,
32-bit based value range 1-
200000000.
interface
no spanning-tree cost
This command configures the path
cost to default for the specific port.
interface
spanning-tree port-priority <0-
240>
This command configures the port
priority for the specific port.
Default: 128.
interface
no spanning-tree port-priority
This command configures the port
priority to default for the specific
port.
configure
interface range
gigabitethernet1/0/PORTLISTS
This command enters the interface
configure node.
if-range
spanning-tree (disable|enable)
This command configures
enables/disables the STP function
for the specific port.
if-range
spanning-tree bpdufilter
(disable|enable)
This command configures
enables/disables the bpdufilter
function for the specific port.
if-range
spanning-tree bpduguard
(disable|enable)
This command configures
enables/disables the bpduguard
function for the specific port.
if-range
spanning-tree rootguard
(disable|enable)
This command enables/disables the
BPDU Root guard port setting for
the specific port.
if-range
spanning-tree edge-port
(disable|enable)
This command enables/disables the
edge port setting for the specific
port.
if-range
spanning-tree cost VALUE
This command configures the cost
for the specific port.
Cost range: