TRENDnet TI-RG262i - Page 77

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
Managed Industrial L2 Switch
74
erps-ring
left-port PORTID type
[owner|neighbor|normal]
This command configures the left port and
type for the ERPS ring.
erps-ring
mel VALUE
This command configures a Control MEL
for the ERPS ring.
erps-ring
name STRING
This command configures a name for the
ERPS ring.
erps-ring
revertive
This command configures the revertive
mode for the ERPS ring.
erps-ring
no revertive
This command configures the non-
revertive mode for the ERPS ring.
erps-ring
right-port PORTID type
[owner|neighbor|normal]
This command configures the right port
and type for the ERPS ring.
erps-ring
ring enable
This command enables the ring.
erps-ring
no ring enable
This command disables the ring.
erps-ring
version
This command configures a version for the
ERPS ring.
erps-ring
wtr-timer
This command configures the WTR Timer
for the ERPS ring. (default: 5 minutes)
config-
erps-inst
instance INSTANCE_ID
control-vlan VLAN_ID
data-vlan VLAN_ID
This command configures a new instance
and specifies its control vlan and data vlan.
config-
erps-inst
no instance INSTANCE_ID
This command removes an instance.
config-
erps-inst
show
This command displays all of the instance
configurations.
Web Configuration
Ring Settings
Advanced Settings > ERPS > Ring Settings
Parameter
Description
Global State
Enables / disables the global ERPS state.
Ring ID
Configures the ring ID. The Valid value is from 1 to 255.
State
Enables/ disables the ring state.
Ring Name
Configures the ring name.(Up to 32 characters)
Revertive
Enables / disables the revertive mode.
Instance
Configures the instance for the ring. The Valid value is from 0 to
30. 0-Disable means the ERPS is running in version 1. The
control VLAN of the instance should be same as below Control
VLAN.