Tridium JACE-6 Series - Page 5

Mounting
Physical Mounting
JACE-6 Mounting and Wiring Instructions
Part Number 10821 Published: April 19, 2007
5
Step 6 Repeat this for all accessories, until all are mounted on the DIN rail and firmly connected to each other.
Step 7 To keep the final assembly together, secure at both ends with DIN rail end-clips provided by the DIN
rail vendor. This also prevents the assembly from sliding on the DIN rail. See Figure 1.
Figure 1 JACE-6 and accessory mounting details.
Mounting on DIN Rail
Removing from DIN Rail
JACE-6
JACE-6
JACE-6
IO-16 (2)
IO-16 (3)
IO-16 (4)
7.13” (181 mm)
6.38” (162 mm)
10.35” (263 mm)
13.58” (345 mm)
16.81” (427 mm)
20.04” (509 mm)
23.27” (591 mm)
IO-16 (1)
4.1”
(104 mm)
2.05” (52 mm)
NOTE: If installing IO-16
modules and using the
NPB-PWR or
NPM-PWR-UN power
supply module, the power
supply module installs at
the end of the chain.
Up to four (4)
IO-16 modules
are supported.
IO-16
Install DIN rail End Clip
(Stop Clip) at both ends of
final assembly.
DIN rail
End Clip
DIN Rail
End Clip
NPB-PWR or
NPB-PWR-UN
NPB-PWR or
NPB-PWR-UN