Triggertrap Mobile App Manual | Page 20
Using Wi-Fi mode
Now that the two devices are connected together, you can
use the Master device to trigger the slaves.
Go to the triggering mode you want to use on the Master
device. Remember to ensure that Wi-Fi triggering is turned
on in the top menu. Now, whenever the Master sends a
trigger signal, the slaves will trigger.
Multiple slaves
You can connect as many slave devices to a master as you
want. Simply follow the instructions above to connect each
slave device to the Master trigger. All the slaves will trigger
at the same time.
What if there is no Wi-Fi network available?
If your Master device has support for ‘Personal Hotspot’, you
can use this instead of a traditional Wi-Fi connection.
Check the documentation for your device for instructions for
how to set up a personal hotspot.
I can’t get my Master / Slave system to work!
It is occasionally tricky to get the two systems to talk to each
other. If that happens to you, try going through these steps:
1. Turn on Airplane Mode on all devices. This resets all
the network connections
2. Turn o Airplane Mode on all devices after 10
seconds.
3. Connect to the Wi-Fi network on all devices
4. Launch Triggertrap Mobile, and turn o Master Mode
on both devices
5. Enter Slave Mode on all the devices you want to
operate as Slaves
6. Turn on Master Mode again on your Master device
7. The Master device will show up on all the Slave
devices, so you will now be able to connect properly.
Network connectivity problems?
If you are still struggling to get your Wi-Fi triggering mode
to work, it could be that there’s something amiss with your
network itself.
WARNING
Please note that some carriers have disabled the use of a
personal hotspot. If this applies to you, please contact your
mobile contract provider to find out how to enable the use of a
‘personal hotspot’ or ‘data connection sharing’.
To Next Page
Loading...