Teaching Keypad New Authority / Access Codes
All codes are exactly 5 digits. You may reuse numbers. Changing the
authority code erases all access codes. It is highly recommended that
you change your authority code from the default code.
Programming Authority Code:
Note: There is a video of how to do this (it will not play on Apple
tablets). http://www.trimarkcorp.com/en/media/Videos/eask/All%
20Keypads/index.html
Preparation:
The keypad is plugged into the coaches wiring harness with a four pin
connector. You will need to unscrew the keypad and pull it away from
the coach to expose this connector. The yellow wire that is tucked into
the sheathing is the wire that initiates programming mode.
Programming:
1. With the keypad still plugged in, short the
yellow wire to the black wire (GND)
momentarily. This will cause the keypad
to beep for one second.
2. Enter the desired 5-digit code twice (after
programming the system will immediately
exit learn mode).
3. Test the code by unlocking the entrance
door
Note: We recommend changing the access code when RV is acquired.
The system automatically stores an access code the same as your
authority code in location Button 1.
Programming Access Codes:
Preparation:
All codes are exactly 5 digits. You may reuse numbers. Have a number
chosen.
Programming:
1. Press and hold Button 3 for 5 seconds. The keypad will beep
and begin flashing when it is held long enough
2. Enter the 5 digit authority code
a. If you enter the correct code you will hear a constant beep
and please continue to step 3
b. If you enter the incorrect code you will hear a 1 second beep.
Please double check the authority code
12
To Next Page
Loading...