Feedback:
If you activate the alarm from keypad, the system will send a
single pulse to the headlights.
If you activate the alarm from the FOB, the system will send a
single pulse to the headlights and horn/siren.
If you fail to activate the alarm the siren will sound 3 times.
Disarming the Alarm:
The alarm system will immediately be disarmed if one of the following
things occurs:
You start the engine
Any unlock signal
The vehicle is put into gear
Cancelling the Alarm:
Any of these conditions will cancel an active alarm:
The vehicle is put into gear
The engine is started
An unlock command of any door/compartment
The alarm timer expires
Tripping the Alarm:
After arming the alarm, if the security input (J1P13) or any of the door
ajar inputs are tripped, the alarm will activate. When active, the siren
will go off and the headlights will flash for one minute.
Auto Locking
Auto Lock / Unlock
The parking brake is monitored to utilize this auto locking feature:
Whenever the vehicle parking brake activates, a timer is started.
Seven seconds later a lock all sequence is done.
Whenever the vehicle parking brake activates, the entrance door
is unlocked.
Parking Brake Description
Engaged Active
The parking brake is active and the vehicle
cannot move. The vehicle is considered “not in
use”.
Disengaged Float
The vehicle will move if no other brakes are
applied. The vehicle is considered “in use”.
This is usually caused by putting the vehicle
into gear.
7
To Next Page
Loading...