Setting Time to Run Hour and Load Run Hour
(Available Only In Dual Source Meter)
The unit has user's programmable two types of times: (i) Run Hour
(ii) Load Run Hour. Run Hour is the time to be counted since the
unit receives power. Load Run Hour is the time to be counted
since the Load receives energy.
To set this time, follow the instructions below:
1. Press key for about four seconds. The unit enters into
Programming Mode and press key till the TIME is
prompting such as shown below.
2. Press key again. Immediately, P starts blinking which
indicates that the parameter can now be changed. Set
TIME to LOAD RUN HOUR or RUN HOUR by pressing
and keys according to user's requirement.
3. Press key to confirm the parameter value. Hence, the
unit will restart and return into Run Mode.
TIME=LoadRunHr
PROG
ENTR
PROG
ENTR
PROG
ENTR
16
Infinity – Operational Manual