17
Infinity – Operational Manual
Setting Energy Parameter for Display:
The unit has user's programmable two types of Energy parameter
for display.(i)KWh (ii)KVAh
To set the energy parameter, follow the instructions below:
1. In Run Mode, press key for about four seconds. The unit
enters into Programming Mode and press key till ENERGY is
prompting such as shown below.
2. Press key again. Immediately, P starts blinking which
indicates that the parameter now can be changed. Set the
parameter to either "KWh" or "KVAh" by pressing and keys.
3. Press key to confirm the parameter value. Hence, the unit
will restart and return into Run Mode.
ENERGY=KWh
PROG
ENTR
PROG
ENTR
PROG
ENTR
To Next Page
Loading...
