CamView IP Pro, Pro-C, and Pro+ User Manual 3
1.2.7 RJ45 Cable Test (CamView IP Pro-C and Pro+ Only)
The Tester may be used to check the condition of the RJ45 cable pairs (normal, open, short) and
perform a cable length measurement test using TDR.
1.2.8 High Definition Analog Camera Test (CamView IP Pro-C and Pro+ Only)
The Tester will display the analog video signal input from an attached analog camera or video
source with AHD or TVI format video output (CamView Pro+ only) or HD-CVI (CamView Pro-C
only). The Tester can provide 12VDC (not to exceed 2.0 Amps) to power the camera. If the camera
has an RS485 port for PTZ control, the Tester can be used to test that functionality. The Tester
provides support for more than 30 PTZ command formats.
1.3 Accessories
One each of the following items are included in the package:
• IP/Analog Camera Tester
• Lanyard
• Battery
• Battery Cover
• Tool Bag with Shoulder Strap
• POE Power Injector
• Network Cable
• BNC Cable
• RS485 Cable
• 12V Power Output Cable
• Audio Cable
• USB Cable
• Screen Protector Film
To Next Page
Loading...
