Opal
15
OPERATING THE SHOWER
IMPORTANT: Make sure the commissioning
procedure has been carried out.
When the electricity supply to the shower is
switched on at the isolating switch, the
POWER
indicator will light.
To start the shower
Water will flow by pressing any of the three
buttons — COLD, ECONOMY or HIGH.
To stop the shower
Press the STOP button and the phased
shutdown will begin. Water will cease to flow
after about four seconds.
To use the control buttons
There are three control buttons — HIGH, COLD
and ECONOMY (fig.22).
The upper button — red symbol
is a high
power setting which allows the highest flow
achievable for your preferred temperature.
This setting should normally be regarded as
optimum shower performance throughout the
year. Temperature adjustment at this setting is
via the temperature control.
The centre button — blue symbol
is for cold
water only. Adjusting the temperature control
at this setting will only increase or decrease the
force of the water from the showerhead. (It will
not alter the water temperature).
The lower button — red symbol
is an
economy setting for using less energy when the
ambient mains water temperature is high during
hot months. Temperature adjustment at this
setting is via the temperature control.
Note: If the stated flow rate required for the
unit cannot be met due to low water pressure,
it will be necessary to operate the unit on this
setting during the warmer months because of
flow rate limitations entering the unit.
To adjust the shower temperature
The water temperature is altered by increasing
or decreasing the flow rate of the water
through the shower via the temperature control
(fig.22).
Stop
button
Temperature
control
Economy
Cold
High
Fig.22
To Next Page
Loading...
Need help?
General
