Opal
23
Fig.45
INSTRUCTIONS FOR INSTALLERS AND SERVICE ENGINEERS ONLY
CLEANING THE INLET FILTER
It is recommended that the filter is periodically
cleaned in order to maintain the performance of
the shower. It is essential that this operation is
carried out by a competent person.
SWITCH OFF THE ELECTRICITY SUPPLY AT
THE MAINS.
The inlet filter is situated in the inlet pipe which
is part of the solenoid valve (fig.45).
To gain access to the filter, remove the trimplate
then disconnect and remove the compression
fitting. Also, depending on the incoming
pipework arrangements, if there is not enough
slack in the pipework, it could mean removing
the unit from the wall.
When cleaning the wire mesh filter,
DO NOT
use a sharp object, as it will cause damage. It is
preferable to use an old toothbrush or similar.
To Next Page
Loading...
Need help?
General
