WHEELS AND TYRES
ROAD WHEEI.S
Pressed
Steel Wheels
(Fig.
43)
Using the
combination tool supplied in the
kit, remove the
nave plate
(hub
cap) by levering at a point adjacent
to one of
the attachment studs.
Progressive\ slacken and detach the
wheel nuts
(R.H.
thread)
with the wheel bmce,
then remove the road wheel.
To refit the wheel, smear the attachment
studs with oil or
trease
to prevent
corosion, fit the wheel and secure
it
by
fitting
AND T\'RES
and progressively
tightening the nuts.
Refit
tbe nave plate by
engaging its m over two of the attacbment
studs and springing
it over the third stud,
by giving it a sharp blow with the palm
of the
hand.
Wire Spoked Wheets
(Fig.
44)
A copper-faced hammer
is
provided
with cars fitted witb
wire spoked
(knock-on)
wheels to facilitate hub cap
removal.
Tum the hub caps, on the dght-hand
side of the car, clockwise
To Next Page
Loading...
