Trivel.com | 13
SETTING THE HANDLEBAR POSITION
Make sure to fully understand how
to use and adjust a quick release
lever before setting the handlebar
position. Failure to properly use this
mechanism can result into the
dismantling of the stem assembly
and lead to a loss of control and
serious injuries. Instructions on how
to use a quick release lever can be
found in the Maintenance and
adjustment section.
Never lift the stem above the
minimum insertion mark engraved
on the lower part of the stem.
Lifting the stem above this mark
can result into the dismantling of
the stem assembly and lead to a
loss of control and serious injuries.
You can easily move the stem (B) up or
down using only the quick-release lever
(A). The stem should be positioned so
that the user has his forearms parallel
to the ground when he holds the
handlebars.
A
B
A. Quick release binder lever
B. Stem
1. Pull the quick release binder lever (A) to its
open position to free the stem (B)
2. Adjust the stem position to the height
required to meet the recommended
arm position
3. Check alignment of the handlebars
with the front wheel. Realign if
not perpendicular.
4. Push the quick release binder lever (A)
back to its closed position to lock the stem
(B) into the new position
To Next Page
Loading...