② Parameter setting：（The following figure gives the reference
value, according to their own needs can be modified）
Layer thickness ： 0.1-0.3mm
Print temp ： PLA - 200 ℃ ABS - 240 ℃
Heatbed temp ： PLA - 50℃ ABS - 80 ℃
Print speed ： 20-150mm/s （suggest 60mm/s）
Support ： Choose according to the model
structure
Platform support： It is recommended to use the
model when the bottom contact is small
Some parameters are set for reference：
14
To Next Page
Loading...
