Layer Thickness
The Layer Thickness function enables the operator to enter the
thickness of the material being measured. When this function
is enabled, the gauge prompts the operator to enter a
thickness value when creating a new project as described on
page 5-3. The layer thickness value is then stored along with
other measurement data in the active project.
To enable or disable the Layer Thickness function, press 〈9〉
from the Setup menu shown on page 2–7. The gauge
displays:
Press 〈1〉 to enable the Layer Thickness function or 〈2〉 to
disable it. The gauge sets the function to the desired state,
displays a brief confirmation message, and returns to the
Setup menu.
1.
ON
2.
OFF
Pr ess # t o Sel ect
To Next Page
Loading...
