Storing Data
The Model 2701-B can store approximately 1000 readings. As
described in the previous section, the gauge stores readings
under the project name that has been enabled. For more
information on selecting a project, see page 5-3.
Project data can be output as described on page 5-7. When
using the Spreadsheet option, the gauge outputs the following
information for each reading:
♦ Project name
♦ Layer Thickness – This value is displayed only if the Layer
Thickness function is enabled.
♦ Record number
♦ Measurement time
♦ Measurement date
♦ Measurement mode
♦ Gmb (Marshall) – This value is 0.0 if the Gmb (Marshall)
target is 0.0.
♦ Gmm (Voidless) – This value is 0.0 if the Gmm (Voidless)
target is 0.0.
♦ Density measurement
♦ Low density – This value is 0.0 if not in segregation mode.
♦ High density – This value is 0.0 if not in segregation mode.
♦ Air voids – This value is 0.0 if Gmm (Voidless) target is 0.0.
♦ Slope
♦ Offset
♦ Gmb (Marshall) target
♦ Gmm (Voidless) target
♦ Mat temperature – This value is 0 if the Temperature
option (see page 2–11) is not installed.
♦ Station ID
To Next Page
Loading...
