Outputting Project Data
The Output function within the Project menu allows the
operator to print (or upload) project data stored in the gauge
to a printer or computer.
1. To output project data, connect a serial cable to the 9-pin
serial port on the front of the gauge. Ensure that the serial
cable meets the pinout shown on page C–3. An optional
serial cable, PN 106514.0002, is available from Troxler.
2. Connect the serial cable to the printer (or computer) serial
port.
NOTE
To upload data to a computer, use the HyperTerminal
application available from the Windows
Accessories
menu. This application can be used to transfer data from
the gauge to the computer.
3. At the Project menu shown on page 5-2, press 〈5〉. The
gauge displays the Output menu:
4. From this menu, the gauge can print (or upload) either a
single project or all projects.
To output the data from all projects, press 〈2〉.
To output a single project, press 〈1〉. The gauge displays:
1.
One Pr oj ect
2.
Al l Pr oj ect s
Pr ess # t o Sel ect
Ar r ows f or Scr ol l
<ENTER> t o Sel ect
To Next Page
Loading...
