GDM-HST02
TEC_TM_158 | REV. B | EN 12/4/2023 Page 23 of 48
truemfg.com
Appliance Operation
• The compressor is ready to operate when the appliance is
purchased. All you need to do is plug in the appliance.
• Good air flow inside your TRUE appliance is critical. Take care
to prevent product from pressing against the sides or back
wall and coming within 4" (101.6 mm) of the evaporator
housing. Refrigerated air off the evaporator coil must circulate
throughout the appliance for even product temperatures.
• Excessive tampering with the control could lead to service
difficulties. If replacing the temperature control is ever
needed, be sure to order the replacement from your TRUE
dealer or recommended service agent.
• All covers and access panels must be in place and properly
secured before operating this appliance.
Startup
Appliance Operation
USER ACTION!
Before loading product, run your TRUE appliance
empty for 24 hours to verify proper operation.
Remember, our factory warranty DOES NOT cover
product loss!
WARNING – SPOILAGE!
The owner is solely responsible for
ensuring safe holding temperature
levels for all food items. Failure to do so
may result in unsafe food products. Loss or spoilage
of products in your appliance is not covered by
warranty. In addition to following recommended
installation procedures, run the appliance for 24 hours
prior to usage to verify operation.
Temperature Control & Light Switch Location
The light symbol
shows the approximate location of the light
switch.
Light Switch on Glass Door Models
Inside the top ceiling.
Electronic Temperature Control
On the front of grill.
To Next Page
Loading...
Need help?
General
