GDM-HST02 truemfg.com
TEC_TM_158 | REV. B | ENP#84066912/4/2023 Page 42 of 48
Maintenance & Servicing (cont.)
General Surface Care & Cleaning
WARNING!
Risk of electrical shock or fire!
DO NOT clean appliance with a pressure washer
or hose.
Slippery Surfaces! Moisture from improper drainage
can create slippery surfaces near the appliance. It is
your duty to immediately warn your customers of, and
dry, the slippery surface. All wet floor areas must be
marked with a wet floor sign.
The appliance owner is responsible for performing
a Personal Protective Equipment (PPE) Hazard
Assessment and to ensure adequate protection during
maintenance and cleaning procedures.
Use appropriate tools, safety equipment, and PPE
during installation and servicing.
Gaskets
• Clean gaskets with warm soapy water.
• DO NOT use sharp tools or knives to scrape a gasket.
• Avoid full-strength cleaning products.
Interior
• Clean interior surfaces with a mild solution of baking soda
and water to help reduce odor; DO NOT use harsh or
abrasive cleaners.
• For plastic or powder-coated parts, use warm soapy water to
clean DO NOT use stainless steel cleaners or similar solvents.
Exterior
• For plastic or powder-coated parts, use warm soapy water to
clean DO NOT use stainless steel cleaners or similar solvents.
• DO NOT clean stainless steel with steel wool or abrasive
products. DO NOT use detergents or degreasers with
chlorides or phosphates. See model-specific manual for more
information.
To Next Page
Loading...
Need help?
General
