GDM-HST02 truemfg.com
TEC_TM_158 | REV. B | ENP#84066912/4/2023 Page 30 of 48
Electronic Temperature Control (cont.)
Enable the Product Loading & Servicing Delay
The Product Loading & Servicing Delay extends the 30-minute
window before the health safety timer activates. This feature
prevents the door from locking when loading or servicing the
appliance. It is enabled automatically upon powering the unit
and following defrost events.
• Total Freezer Delay: 105 minutes
• Total Refrigerator Delay: 60 minutes
The Product Loading & Servicing Delay can also be manually
initiated with the instructions below.
1. Press info to show hSt.
2. Press and hold info until the display shows 00.
DO NOT RELEASE THE BUTTON!
3. While holding info, press the up arrow until the display
shows 01.
4. Release all buttons and wait for the control display to
alternate between hSt and dLY.
Test the Health Safety Lock
The Health Safety Lock locks the appliance door when the
electronic control detects the appliance temperature has been
above a preset temperature for 30 minutes.
1. Press info to show hSt.
2. Press and hold info until the display shows 00.
DO NOT RELEASE THE BUTTON!
3. While holding info, press the up arrow until the display
shows 23.
4. Release all buttons. If operational, the Health Safety Lock
will activate.
5. Clear the Health Safety Alarm. See “Clear the Health Safety
Alarm or Product Loading & Servicing Delay”.
LAE CONTROL LEGEND
Info/Set Point Manual Activation/
Up Arrow
Manual Defrost/
Down Arrow
Stand-By/
Cancel
Compressor Running
Activation of 2
nd
Parameter Set
Alarm
Appliance in Defrost
Evaporator Fan Running
To Next Page
Loading...
Need help?
General
