What does Fault CN04 mean on my True PERFORMANCE 1000 Treadmill?
Fault CN04 on your True Treadmill indicates a Lower Board Comm Fault. You can try power cycling the machine and checking the cable connections.
Why does my True Treadmill make a rubbing sound when I use it?
A rubbing sound from your True Treadmill during operation can be due to several factors: 1. The walking belt may be rubbing against a straddle cover. 2. A foreign object might be stuck under the walking belt. Inspect under the unit and remove any objects.
What should I do if the walking belt on my True PERFORMANCE 1000 hesitates or slips?
If the walking belt on your True Treadmill hesitates or slips when you step on it: * Adjust the belt tension. * Lubricate the running belt.
How do I fix a True PERFORMANCE 1000 Treadmill walking belt that is off center?
To fix a True Treadmill walking belt that's off-center: * Adjust the treadmill rear leveling feet if the floor is uneven. * Adjust the belt tracking.
How to fix a True Treadmill with no power?
If your True Treadmill has no power, there are several potential causes and solutions: 1. Ensure the On/Off switch is in the ON position. 2. Inspect the power cord for damage; if damaged, replace it. 3. Check that the power cord is fully seated in the socket at both the unit and the outlet. 4. Use a voltmeter to verify that there is power at the outlet. 5. Check the circuit breaker next to the On/Off switch to ensure it is not open; if it is, reset it.
To Next Page
General
