T S 1 O W N E R ’ S G U I D E
How to Use Test Mode
CHAPTER TEN: TEST MODE
71
TEST MODE
How to
Use These
Functions
EPROM Test: Software version.
Key Test: A diagram of the keypad is shown in the matrix display.
Press each key to make that key’s “dot” to disappear and to show a
description of the key in the message center.
Display Test: Various tests of the LCD display.
Control Test: Direct readout of eddy coil current.
Heart Rate Test: Shows both Polar and contact heart rate signals.
RS232 Test: Not implemented at this time.
A/D Channels: Displays value from each of the analog inputs.
Press
key to move to the next input. Inputs are load sense, brake
sense, load control, left upper backlight, right upper back light and
lower back light.
Brake/Pedal RPM: Shows both values at the same time.
Watchdog Test: Internal hardware test.
To Next Page
Loading...
