5. Put the new seat into the tubes and put in the two
metal rods. Make sure that the direction of the seat is
correct. If necessary exchange the rods and dome nuts.
6. Screw the dome nuts in place.
7. Put the fabric band into the slot in the unfold hook.
Adjust the length of the band so that the hook locks the
rollator in open position and releases when you lift the
seat in the middle opening.
Let’s Fly Spare part. Art. No. LF301, LF302. Art. No. LF324.
13. www.trustcare.se
Let’s Fly Service Manual. Revision version No: 2 – Aug 2017
Exchange of seat and seat mounting set.
1. Partly fold the rollator so that the
seat is loose and not stretched.
2. Screw off the dome nuts in one
end, both sides of seat. Use allen
keys if necessary. Pull out the rods.
3. Remove the fabric band from the
unfold hook.
4. If the seat is to be exchanged, pull out the seat from
the metal tubes.
To Next Page
