63
Gap Setting 0.12"(3.0mm)
Print Direction 0
Reference Point 0,0(upper left corner)
Offset 0
Tear Mode On
Peel off Mode Off
Serial Port Settings 9600 bps, none parity, 8 data bits, 1 stop bit
Code Page 850
Country Code 001
Clear Flash Memory No
Shift 0
Gap Intension Will be reset. Need to re-calibrate the gap
sensor
Bline Intension Will be reset. Need to re-calibrate the bline
sensor
LCD Contrast 50
Back Light off Time 10 sec
Low Power Time Off
Shut Down Time Off
Please follow the steps below to initialize the printer.
1. Turn off the printer power.
2. Hold down the middle and right buttons and turn on the printer power.
3. Do not release the buttons until printer LCD shows "Initializing..." as below.
Note : When printer initialization is done, please calibrate the gap or black
mark sensor again.
Initializing...
To Next Page
Loading...
Need help?
General
