How to solve wrinkle problems with a TSC MB340T Printer?
If you are experiencing a wrinkle problem with your TSC printer: * Refer to the next chapter. * Set a suitable density for good print quality. * Ensure the label guide touches the edge of the media guide.
How to remove a gray line on blank labels from a TSC printer?
If there's a gray line on the blank label when using your TSC printer, clean the print head and the platen roller.
What to do if my TSC MB340T is not printing?
If your TSC printer isn't printing, try the following: * Reconnect the cable to the interface or use a new cable. * Reset the wireless device setting. * Select the correct printer port in the driver. * Clean the printhead. * Turn off the printer and plug the connector in again. * Check your program for a PRINT command at the end of the file and ensure there is CRLF at the end of each command line.
How to fix missing print on the sides of labels with a TSC MB340T?
If your TSC printer is missing printing on the left or right side of the label, set the correct label size.
What to do if my TSC MB340T Printer shows 'No Paper'?
If your TSC printer indicates 'No Paper', you should: * Supply a new label roll. * Refer to the user’s manual for instructions on reinstalling the label roll. * Calibrate the gap/black mark sensor.
How to fix label feeding if it's unstable (skew) on my TSC printer?
If the label feeding is not stable (skew) when printing with your TSC printer: * If the label moves to the right, move the label guide to the left. * If the label moves to the left, move the label guide to the right.
How to fix a TSC printer when the power indicator does not illuminate?
If the power indicator on your TSC printer is not illuminating: * Plug the power cord into both the printer and the outlet. * Switch the printer on.
What to do if my TSC MB340T Printer has a paper jam?
If your TSC printer has a paper jam, try the following: * Calibrate the media sensor. * Set the media size correctly. * Remove any stuck labels inside the printer mechanism.
How to fix paper jam in TSC Barcode Reader?
If your TSC Barcode Reader is experiencing paper jams, it could be due to a few reasons. First, the gap/black mark sensor may not be set properly; try calibrating the media sensor. Second, ensure that the label size is set correctly. Finally, labels may be stuck inside the printer mechanism; remove any stuck labels.
What to do if my TSC Barcode Reader displays 'No Ribbon'?
If your TSC Barcode Reader displays 'No Ribbon', it could be that the ribbon roll is depleted. Replace it with a new ribbon roll. Alternatively, the ribbon might be installed incorrectly. Consult the user’s manual for instructions on how to reinstall the ribbon correctly.
Guide to configuring the printer's Ethernet settings using a USB connection.
Guide to configuring the printer's Ethernet settings using an RS-232 connection.
Guide to configuring Ethernet settings directly over the network connection.
Configuration options for TSPL programming language, including speed and density.
Configuration options for ZPL2 programming language, including density and print speed.
Procedures for calibrating media sensors for accurate printing.
Configuration options for the RS-232 serial port, including baud rate and parity.
Settings for the printer's Ethernet module, including IP and DHCP options.
Configuration options for Wi-Fi connectivity, including SSID, security, and password.
Settings for the printer's Bluetooth module, including local name and ping code.
Settings for language, display, security, cutter, warnings, and printer care.
Using diagnostic functions to check configuration, print head, display, and sensors.
Guide to identifying and resolving common operational problems with the printer.
Instructions for cleaning printer parts like the print head and platen roller.
To Next Page
General