“Set IP” to take effect the settings.
Users can also change the “Printer Name” by another model name in this fields then click
“Set Printer Name” to take effect this change.
Note: After clicking the “Set Printer Name” or “Set IP” button, printer will reset to
take effect the settings.
8. Click “Exit” button to exit the Ethernet interface setup and go back to Diagnostic Tool main
screen.
Factory Default button
This function will reset the IP, subnet mask, gateway parameters obtained by DHCP and
reset the printer name.
Web setup button
Except to use the Diagnostic Utility to setup the printer, you can also explore and
configure the printer settings and status or update the firmware with the IE or Firefox web
browser. This feature provides a user friendly setup interface and the capability to
manage the printer remotely over a network.
To Next Page
Loading...
